The DPA616 is a professional sixteen channel power amplifier which is capable of delivering a power of 60 Watt to 4 Ohm loads connected to the 16 output channels.

Signal / Noise> 100 dB
THD+N (@ 1 kHz)< 0.1%
ProtectionDC Short circuit
 Over heating
 Over load
 Signal limiting
Operating temperature0° ~ 40° @ 95% Humidity
FrequencyResponse (± 3 dB)20 Hz – 20 kHz
InputsSensitivity (1W/1m)-20 dB ~ +20 dB
 Connector3-pin Euro Terminal Block (Pitch – 3.81 mm)
OutputsConnector4-pin Euro Terminal Block (Pitch – 5.08 mm)
PowerSupplySwitching mode
 Source100 ~ 240 V AC / 50 ~ 60 Hz
RMS Power@ 4 Ω Stereo16 x 60 W
 @ 8 Ω Bridge8 x 120 W
 @ 8 Ω Stereo16 x 30 W

Dimensions482 x 88 x 322 mm (W x H x D)
Weight8.200 kg
Unit height2 HE
AccessoriesIncluded16 x 3-pin Euro Terminal Block Input connectors
  8 x 4-pin Euro Terminal Block outputs connector

When used in bridge mode, it can deliver a power of 120 Watt to 8 Ohm loads connected to the 8 bridged outputs. This way, the DPA616 is the perfect solution for installed multi-zone audio distribution systems with 8 or 16 zones. This amplifier is designed as a no-nonsense amplifier with only the necessary controls and connections which creates great simplicity in use and installation. The input connections are all performed with 3-pin Terminal block connectors, allowing the connection of balanced input signals. 


Every channel is fitted with a separate gain control potentiometer and for every two input connectors, there is a stereo / bridge & parallel switch provided whereby two channels can be bridged or linked in parallel, avoiding a cable clutter when multiple channels should be fed with the same input signal. 


The output connections are performed with 4-pin Terminal block connectors allowing connections for separate or bridged output channels. A built-in multipurpose protection circuit protects against DC malfunction, short circuit, overheating, overload and limits the signal when necessary. This all is housed in a double rack space, steel 19” rack mount housing.